How to Install a License Plate Delete Kit

Quick answer

Installing a license plate delete kit takes about 20 minutes. Remove the factory plate bracket, align the new plate over the mounting holes, and secure it with the provided hardware.

Installation steps

1. Step 1: Remove the factory plate bracket: Use a screwdriver or socket set to unbolt the stock license plate bracket from your front bumper. Keep the original screws in case you need them later. Common mistake: Forgetting to remove any adhesive foam or double-sided tape that may remain on the bumper. Check the bumper surface for leftover residue before proceeding.
2. Step 2: Align the delete plate over the mounting holes: Hold the Billetworkz license plate delete up to the bumper, lining up the pre-drilled holes with the existing mounting points. It should sit flush without forcing. Common mistake: Misaligning the plate can cause uneven gaps or scratches on the anodized finish. Test fit before tightening to avoid damage.
3. Step 3: Secure the plate with the supplied hardware: Thread the screws or bolts through the plate into the bumper's mounting holes. Tighten by hand until snug, then give a quarter turn with the tool. Do not overtighten—aluminum threads can strip. Common mistake: Over-torquing can crack the anodized coating or warp the plate. Stop turning once the plate feels firm against the bumper.
4. Step 4: Final inspection: Step back and check that the plate is level and centered. Wipe down the anodized surface with a microfiber cloth to remove fingerprints. Common mistake: Ignoring a slight tilt that becomes obvious from a distance.

Product facts

• Billetworkz "American Flag - Classic" License Plate Delete: CNC-milled aluminum with an anodized finish that resists scratches and corrosion. The anodized finish keeps your plate looking new even after years of weather exposure.