Billetworkz Alcantara Kit Install: Shift and E-Brake Boots

By Custom Shift Knobs & Interior Mods | Published: 2026-10-25

Category: How-to Guides

Step-by-step guide to installing the Billetworkz Alcantara shift boot and e-brake boot kit on a 2022+ Subaru BRZ or Toyota GR86 automatic.

Quick answer

Installing the Billetworkz Alcantara shift boot and e-brake boot kit on a 2022+ automatic Subaru BRZ or Toyota GR86 is a straightforward interior upgrade that takes about 30 minutes with basic hand tools.

Why upgrade to Alcantara boots?

The shift boot and e-brake boot are two of the most frequently touched surfaces in your cabin. Replacing the factory plastic or pleather with authentic Alcantara immediately gives the interior a more refined, sporty feel. The suede-like texture is a signature material in performance cars and holds up well with normal use.

What you need before starting

You'll need a flathead screwdriver (or plastic trim tool), a small Phillips-head screwdriver, and good lighting. The kit includes the shift boot and e-brake boot pre-sewn to fit the 2022+ BRZ/GR86 automatic console. No cutting or sewing is required.

Installation steps

Remove the shift knob: Grip the shift knob firmly and pull straight up. On automatic models, the knob is a push-fit without set screws. If it feels stuck, rock it gently side to side while pulling. Don't use excessive force or tools that could scratch the shaft.
Pry up the shift boot trim ring: Insert a flathead screwdriver or trim tool under the front edge of the chrome trim ring around the shift boot. Gently pry upward until the ring pops free. Disconnect any wiring for the shift indicator if present (usually a small clip). Work slowly to avoid cracking the plastic trim ring.
Remove the old shift boot: The factory boot is held by plastic tabs or a small bracket. Unclip or unscrew it from the console. Slide the boot down and off the shift lever. Note the orientation of the factory boot so you can match the new one.
Install the new Alcantara shift boot: Slide the Billetworkz boot over the shift lever. Align the mounting holes with the console tabs. Press the trim ring back into place until it clicks. Reconnect any wiring clips. Make sure the boot is not twisted before snapping the ring down.
Remove the e-brake boot: Pull up on the e-brake handle to access the base. The factory boot is held by a plastic retainer or screws. Remove the retainer and slide the old boot off the handle. If the retainer is brittle, work carefully to avoid breaking it.
Install the new e-brake boot: Slide the new Alcantara boot over the e-brake handle. Push it down until it seats flush against the console. Reinstall the retainer or screws to secure it. Test the e-brake operation after installation to ensure the boot doesn't bind.
Reinstall the shift knob: Press the shift knob back onto the shaft until it clicks into place. Confirm it's fully seated by pulling up gently. If the knob feels loose, remove and re-seat it—don't force it.

Product details

Billetworkz Alcantara Kit (Starter): Shift Boot and E-Brake Boot Kit – Subaru BRZ/Toyota GR86 2022+ (Automatic): The Billetworkz Alcantara Kit (Starter) includes a shift boot and e-brake boot pre-fitted for the 2022+ Subaru BRZ/Toyota GR86 automatic. It eliminates the need for custom trimming or sewing, making installation accessible to anyone with basic DIY skills.
Billetworkz Alcantara Kit (Starter): Shift Boot and E-Brake Boot Kit – Subaru BRZ/Toyota GR86 2022+ (Automatic)